Product Details
LISN LINE IMPEDANCE
STABILISATION NETWORKS
A complete range for commercial, automotive and military applications.
- From single line up to 4 line.
- 16 Amps to 500 Amps.
- CISPR16, CISPR25, Def Stan, Mil Spec and specialist types supplied.
- All LISN'S supplied fully compliant and calibrated.
- All commercial types include transient limiter and feature 0dB insertion loss.
CISPR16, single phase, 16 amp LISNCOMPREHENSIVE
The Laplace range of LISNs covers an exceptionally wide scope, covering all applications from commercial and industrial to military , aerospace satellite.COMPLIANCE
All Laplace LISNs are fully compliant with the appropriate standard and are shipped complete with calibration data.PROTECTION
All standard CISPR16 LISNs are fitted with a transient limiter and include a separate pre-ampflier to give a 0dB insertion loss.CONVENIENCE
Commercial LISN'S are fitted with standard mains outlets. Country-specific types can be specified at time of ordering. Single pole jack sockets are normally also included so that individual conductors can be connected.When measuring EMC emissions conducted from the equipment-under-test (EUT) most standards specify a LISN (or artificial mains V-network) to couple the RF from the cable and to provide a repeatable impedance at the measured frequencies. All laplace LISN's fully comply with the relevant standards and feature a rigorous, individual calibration with hardcopy of results issued by a uk test laboratory.
General Specifcations RF Output socket: 50 ohm, BNC for each line. EUT line connections: Single pole shrouded sockets
< 32A = 4mm
> 32A = 6mm
Additionally for 16A type, domestic mains outlet fitted. Specify UK, US, Schuko(Euro) or As/NZ type when ordering.Termination impedance: Internal Ground bond: Stud terminal on front panel. Artificial hand output: All CISPR16 LISNs fitted (220pF || 510 ohms). Operating temperature: -5°C to +40°C Transient protection level: 150dBuV Earth Leakage current 80mA Line voltage:
Single phase:
3 Phase:Up to 250V ac rms
Up to 415V ac rms
LISNs Specification Model number Standard Current rating (Amps) Phases Internal Transient limiter Frequency Range Size LISN-16A1P CISPR16 16 L,N 150KHz- 30MHz A LISN-32A1P CISPR16 32 L,N 150KHz- 30MHz B LISN-63A1P CISPR16 63 L,N 150KHz- 30MHz B LISN-100A1P CISPR16 100 L,N 150KHz- 30MHz B LISN-32A3P CISPR16 32 L1,L2,L3,N 150KHz- 30MHz C LISN-63A3P CISPR16 63 L1,L2,L3,N 150KHz- 30MHz C LISN-100A3P CISPR16 100 L1,L2,L3,N 150KHz- 30MHz C LISN-200A1P CISPR16 200 L1,N 150KHz- 30MHz D LISN-200A3P CISPR16 200 L1,L2,L3,N 150KHz- 30MHz D LISN-C25/100A CISPR25 100 1 no 100KHz- 100MHz E LISN-C25/500A CISPR25 500 1 no 100KHz- 100MHz F LISN59-41/100 Def Stan 59-41 100 1 no 20Hz- 400MHz E LISN461E/100A Mil 461E 100A 1 no E
Size Code W x H x D (mm) Type A 180 x 80 x 300 Flanged box B 483 x 6u x 422 Instr. Case C 483 x 9u x 522 Instr. Case D Instr. Case E 180 x 90 x 500 Flanged box F 180 x 120 x 500 Flanged box
Accessories LISN-TS External transient limiter for use with LISNs not fitted with internal transient limiter.
Insertion loss = 0dB,
Bandwidth 9KHz - 400MHz Mains supply requiredVoltage Probe PLIP Power Line Interference Probe..... See separate information sheet.
Complies with CISPR16.
Insertion loss nominally 0dB.
No restriction on EUT supply current
For use in circumstances when a LISN is not appropriate (e.g. current >100A, permanent installation.....)
Includes 1kV isolation, transient limiter and 30dB amplifier.Emission tester PLIPMAN Complete Portable conducted emissions tester....See separate information sheet
Includes voltage probe and emissions measuring unit giving readout of frequency and dBuV
Enables shop-floor and on-site measurements to be made easily and quickly.
Single phase and 3 phase operation (500V AC rms, max.)
Internal rechargeable batteries fitted and battery charger supplied.View Adobe PDF File
|
|
||
| LAPLACE INSTRUMENTS
LTD 3B, Middlebrook Way, Holt Road, Cromer, Norfolk, NR27 9JR, UK |
Tel: + 44 (0)1263 515160 Fax: + 44 (0)1263 512532 E-mail:tech@laplace.co.uk |
|
|
|
||
